Fjo Pmnc problem
11-29-2013, 10:59 AM
#1
Staging Lane
Thread Starter
iTrader: (10)
Join Date: Jul 2006
Location: Inez, Ky
Posts: 74
Likes: 0
Received 0 Likes
on
0 Posts
Fjo Pmnc problem I know fjo is out of buisness so any help is appreciated. I have been trying to get it to connected to my computer and it isnt working i am using windows 7. I have already tried this.
http://www.trickperformanceproducts....tion_error.pdf
And no luck . Everyone says it has to do with the drivers being installed wrong but i cant figure it out. And idea what i can do
http://www.trickperformanceproducts....tion_error.pdf
And no luck . Everyone says it has to do with the drivers being installed wrong but i cant figure it out. And idea what i can do
12-01-2013, 01:01 AM
#2
Have you tried the compatibility mode?
I'm not sure what Pmnc is... the best I can offer is installing the NX Maximizer II and/or FJO WB software on a work machine with Windows 7 and trying to get it to work... but those controllers (along with most mods) are boxed somewhere in an attic, so I need to hunt them down first
I'm not sure what Pmnc is... the best I can offer is installing the NX Maximizer II and/or FJO WB software on a work machine with Windows 7 and trying to get it to work... but those controllers (along with most mods) are boxed somewhere in an attic, so I need to hunt them down first
12-03-2013, 09:48 AM
#3
Staging Lane
Thread Starter
iTrader: (10)
Join Date: Jul 2006
Location: Inez, Ky
Posts: 74
Likes: 0
Received 0 Likes
on
0 Posts
progressive nitrous mini controller I tried this compatibly mode. Still not working. When i connect the usb cable it shows it is connected to silicon labs cp210x usb to uart bridge {com3} I think that it isnt picking the right driver for it.
Last edited by Billy1987; 12-03-2013 at 10:12 AM.