fitting a 9inch
#1
Staging Lane
Thread Starter
Join Date: Nov 2010
Location: Leicester NY
Posts: 54
Likes: 0
Received 0 Likes
on
0 Posts
fitting a 9inch
hey guys i just fell into a mosher 9 inch for my 2000 z28.. looking for some drive shaft measurements for a new drive shaft for the 9inch to the t-56... and any other heads ups you guys can give me before i dive into this project.. any idea on changing yokes?? this will be my first rear end swap so any help is greatly appreciated!! thanks in advance guys!! Tim.
#4
Sounds like a straight forward deal, my driveshaft for my 9" to a t56 was 1" longer then stock. Some guys run the stock driveshaft with a ujoint conversion but I wouldn't want to drive it hard. Long story short just order from a vendor on here and tell the it's a 9" with t56 they will know the measurements (1" longer then stock)
#7
LS1Tech Sponsor
iTrader: (16)
Thanks, I appreciate the order! Bob
__________________
ATI ProCharger and Moser Sales 260 672-2076
PM's disabled, please e-mail me
E-mail: brutespeed@gmail.comob@brutespeed.com
https://brutespeed.com/ Link to website
ATI ProCharger and Moser Sales 260 672-2076
PM's disabled, please e-mail me
E-mail: brutespeed@gmail.comob@brutespeed.com
https://brutespeed.com/ Link to website
Trending Topics
#11
LS1Tech Sponsor
iTrader: (16)
Yes it is, both the 4L60E and T-56 take the same length driveshaft. Bob
__________________
ATI ProCharger and Moser Sales 260 672-2076
PM's disabled, please e-mail me
E-mail: brutespeed@gmail.comob@brutespeed.com
https://brutespeed.com/ Link to website
ATI ProCharger and Moser Sales 260 672-2076
PM's disabled, please e-mail me
E-mail: brutespeed@gmail.comob@brutespeed.com
https://brutespeed.com/ Link to website