New fabricated valve covers
#1
On The Tree
Thread Starter
iTrader: (1)
Join Date: Aug 2003
Location: Turlock, CA
Posts: 167
Likes: 0
Received 0 Likes
on
0 Posts
New fabricated valve covers
What do you guys think of these fabricated valve covers I had made. I had them include a -10AN fitting on each to run to a catch can/breather and also custom coil brackets. The quality of these are awesome!! Just seeing what everyone thinks as I told the builder I'd give him feedback .
Trending Topics
#13
On The Tree
Thread Starter
iTrader: (1)
Join Date: Aug 2003
Location: Turlock, CA
Posts: 167
Likes: 0
Received 0 Likes
on
0 Posts
No I had to baffles added as Im going to be running these to a catch can to vent so I didn't see the need (plus clearance may be an issue since I'm running jesel's). These do look very similar to the ones Nate carries, but can't say for sure as I dont know who fabricates the ones Nate carries.
#16
On The Tree
Thread Starter
iTrader: (1)
Join Date: Aug 2003
Location: Turlock, CA
Posts: 167
Likes: 0
Received 0 Likes
on
0 Posts
Thanks . The point of the catch can is that I have run just breathers before and on high G corning oil would actually come out of the breathers and run down onto the headers, etc.
#18
TECH Fanatic
Join Date: Feb 2003
Location: Columbus, OH
Posts: 1,586
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by SStolen
I don't get the point of a catch can. Just put some breathers on there and eliminate the possibility of oil even going into the intake to begin with. If I'm wrong, school me .