Bill's 02 Z-28 SS

Hi folks,
M6 02 SS
I just spend a hour reviewing all old threads on Torque Management (TM)table/max. I am sure, I don't fully understand this one, everybody agrees that once TM kicks in, it takes out timing-OK. I see most people deleting the table and setting MAX=~1000. My question is why delete the table, just set the MAX from 350 to 1000 or some number higher than 350? Also the table is set to 650 but MAX is set to 350. I assume once the calculated torque goes past 350 something happens, which I think is taking out timing - is this correct?
Thanks

Bill

SmokingWS6

iTrader: (1)

TM during shifts is different from max torque output. Max TQ will pull timing at any point if it exceded the set limit, not just during shifts. I put my TQ to 450 as a last protection for my transmission.

Bill's 02 Z-28 SS

Thanks - I set my at 450 but did it truly by guess work -
Bill

wait4me

iTrader: (10)

i normally set it too 600, no many cars out there have more than that in torque, the limit is 640 anything higher and the pcm starts acting weird sometimes.. jes