Can I use Barb fittings on fuel system
01-09-2005, 03:09 PM
#4
TECH Enthusiast
Thread Starter
iTrader: (1)
Join Date: May 2004
Posts: 520
Likes: 0
Received 0 Likes
on
0 Posts
Correct me if I'm wrong here but I work day in/out on Nissan Skylines and they just use EFI rubber hose and normal hose clamps on the whole fuel system and its all factory fitted.
They use a bundy style end on everything.
Would bundy style be ok to use, I just want to get the car up and running and driveable and save some more pennies then put AN fittings throughout and probably change to billet rails and an adjustable reg and dont want to have to make up 2 sets of braided lines when I change.
They use a bundy style end on everything.
Would bundy style be ok to use, I just want to get the car up and running and driveable and save some more pennies then put AN fittings throughout and probably change to billet rails and an adjustable reg and dont want to have to make up 2 sets of braided lines when I change.
01-09-2005, 08:14 PM
#5
I have bought Autozone/Advance quick connect fittings that just have a ridge about 1/4" back from the end. Slide the fuel injection hose over the ridge, put on a clamp and go. These fittings routinely saw 80 psi when the car was still a v6 with a blower and fmu....
