My90Iroc

iTrader: (26)

I picked up an 85mm MAF supposedly used on Z06's (p/n 25168491). I don't really see a reason to buy the TSP 85mm lid if I can find a bellow that would butt the MAF to my existing SLP lid. I've heard of this before but my question is where do you find a bellow that will fit?

The outer diameter of both the MAF and lid seem to be about 3.8" kind of an in between size. Thanks for the help.

SUX2BU

iTrader: (14)

4" silicone hose will work. i think i have some $20 if i can find it.

orangeapeel

iTrader: (18)

Home Depot! cheap$$$ Do the Fernco route I think that they make a 4' peice. Of course you would be doing some trimming, but I hear that you have to do that on the SLP one too and it is freaking almost 50$. Save money.

My90Iroc

iTrader: (26)

The MAF is small than 4" and it looked like there was a gap left when I tried the 4" piece. Will the hose clamp squeeze tight enough to close this gap down?

orangeapeel

iTrader: (18)

yeah, it may buckle a tad as well. but the 3 was a pita to get onto the stock maf end.

TAQuickness

iTrader: (28)

you can get a thin 3" ferco style bellows at home depot. get it hot (boil it or hair dryer) and it will stretch. They cost about $3