A little old news
#1
LS1TECH Sponsor
Thread Starter
Join Date: Nov 2004
Location: Michigan
Posts: 344
Likes: 0
Received 0 Likes
on
0 Posts
A little old news
but I though some of you would dig it anyways.
Earlier this year Engine Masters ran a full build article on the engine we used in Casper to break into the 6's and I found they featured it on their website.
All and all the article is really good and even lists just about every part used in the engine showing we don't have to be the fastest guys with top secret parts.
Just thought I would share for those who may not of seen it.
http://popularhotrodding.com/enginem...511phr_engls1/
Earlier this year Engine Masters ran a full build article on the engine we used in Casper to break into the 6's and I found they featured it on their website.
All and all the article is really good and even lists just about every part used in the engine showing we don't have to be the fastest guys with top secret parts.
Just thought I would share for those who may not of seen it.
http://popularhotrodding.com/enginem...511phr_engls1/
#4
9 Second Club
iTrader: (2)
Join Date: Jun 2005
Location: Reston, VA
Posts: 2,034
Likes: 0
Received 0 Likes
on
0 Posts
Kevin... that is friggin amazing. That is why W2W has the rep they do. You guys produce an amazing product. Out of pure wonder... what would a setup like that cost a customer off the street?
They needed 100HP shot of NoS just to Stall up the car!!!!
They needed 100HP shot of NoS just to Stall up the car!!!!
Last edited by longrange4u; 02-02-2006 at 03:17 PM.
#5
LS1TECH Sponsor
Thread Starter
Join Date: Nov 2004
Location: Michigan
Posts: 344
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by longrange4u
Kevin... that is friggin amazing. That is why W2W has the rep they do. You guys produce an amazing product. Out of pure wonder... what would a setup like that cost a customer off the street?
We have had a few inquiries on duplicating the set up and it really depends on the exact combination for the customer considering our engine used a lot of employee parts.
Short block could be duplicated around 16k
To do something around the same level with tuning and other options could run 25k to 40k pretty quick.
And if anyone is seriously interest the engine used in Casper could be sold as it sits right now
#7
TECH Apprentice
iTrader: (8)
Join Date: Nov 2005
Location: Colorado Springs
Posts: 311
Likes: 0
Received 0 Likes
on
0 Posts
So Kevin, do you have any more"spare parts" around If you could put them together in an old block and ship it to me that would be cool. About all I can pay is the shipping though. We enlisted military folks don't make that much