stainless works headers
#2
TECH Addict
I don't think many have them, but I know a few do because I've looked into them as well. I've only ever seen GREAT comments about them, in terms of fit and finish and performance. And I've never seen a bad word about them.
If I was wanting to spend that kind of money on headers they would certainly be one I'd be looking at
If I was wanting to spend that kind of money on headers they would certainly be one I'd be looking at
#4
Originally Posted by byler900f
Just wanted to see if anybody is running or heard anything about stainless works headers?
I have used them... Good product and good QC... My experience was not with a F-Body though...
#6
Launching!
iTrader: (6)
Join Date: Aug 2005
Location: Texas
Posts: 208
Likes: 0
Received 0 Likes
on
0 Posts
I have Stainless Works on my Hawk and I put down 335rwhp/343rwtq with that and a lid. Quality is excellent on them. FItment of the longtubes was great. The Y-Pipe that came with them was about an inch too long at the connection with the I-Pipe. Other than that, I am very happy with them. Would buy from them again if I had to.
#7
On my 01 ws6 i put down 330rwhp and 350rwtq with their headers and catted y-pipe(random techs) through a borla with open plate and a lid with no tuning. Fitment had some issues, had to cut the y-pipe in a couple spots to get it to fit. Almost seemed like it was an ORY not leaving room for the cats. The y-pipe also hits the floor, but only because i think the angle off the primaries into the collector is pointing up slightly. Some others have had this problems and some haven't. Other then that they are a quality piece good welds ect. and i'm happy with them. and FWIW I made those numbers with the 2 1/2" y-pipe
also forgot to mention that ground clearance is just as good as stock or better.
also forgot to mention that ground clearance is just as good as stock or better.