06 Procharged Mustang GT Dyno Results!
#1
8 Sec Tuner
Thread Starter
iTrader: (2)
Join Date: Jan 2002
Location: Wish I was in a boat fishing...
Posts: 4,641
Likes: 0
Received 0 Likes
on
0 Posts
06 Procharged Mustang GT Dyno Results!
We just finished up our 06 Mustang GT Project this morning. Here's a rundown of the setup.
Kooks 1 5/8 Longtube Headers with Catted X-Pipe
Borla Cat-Back Exhaust
SPEC Stage 3 Clutch
3:73 Rear-Gear
P-1SC Procharger @ 9.5 PSI
This tune is super conservative. We can easily reach 500RWHP without increasing the boost but we don't want to push this stock short-block too far. Eventually the customer wants to do a low-compression stroker motor, upgrade to the D-1SC blower and turn the boost up!
Kooks 1 5/8 Longtube Headers with Catted X-Pipe
Borla Cat-Back Exhaust
SPEC Stage 3 Clutch
3:73 Rear-Gear
P-1SC Procharger @ 9.5 PSI
This tune is super conservative. We can easily reach 500RWHP without increasing the boost but we don't want to push this stock short-block too far. Eventually the customer wants to do a low-compression stroker motor, upgrade to the D-1SC blower and turn the boost up!
Last edited by Mike TexaSS; 06-09-2006 at 11:20 AM.
#4
Administrator
Pretty stout numbers. Those 3V's respond pretty well to boost...as do most
cars I guess. Even with a conservative tune, I'd be a little concerned about
that stock short block.
cars I guess. Even with a conservative tune, I'd be a little concerned about
that stock short block.