Replaced the 2bar with a 3bar today....+ Boost.
#1
Coal Mining Director
Thread Starter
iTrader: (17)
Join Date: Nov 2001
Location: Virginia
Posts: 4,442
Likes: 0
Received 0 Likes
on
0 Posts
Replaced the 2bar with a 3bar today....+ Boost.
Oh GAWDDDDDDDDDDDDDDDDDDDD
Fire shooting out of the tailpipes.....roasted 2 pet kittens
Actually all is good. Biggest tip is to get the scalar set to key on engine off to your actual kPa. It was only a little richer than the 2bar at part throttle. Dead on at WOT. Drove great on the 2bar tune....I'll fine tune it tomorrow.
Delphi 3bar part number 12223861 sold by Speed Inc under the FAST brand and many others...great low end resolution.....don't waste your time or money on a 2 bar map like I did.
Fire shooting out of the tailpipes.....roasted 2 pet kittens
Actually all is good. Biggest tip is to get the scalar set to key on engine off to your actual kPa. It was only a little richer than the 2bar at part throttle. Dead on at WOT. Drove great on the 2bar tune....I'll fine tune it tomorrow.
Delphi 3bar part number 12223861 sold by Speed Inc under the FAST brand and many others...great low end resolution.....don't waste your time or money on a 2 bar map like I did.
#3
Coal Mining Director
Thread Starter
iTrader: (17)
Join Date: Nov 2001
Location: Virginia
Posts: 4,442
Likes: 0
Received 0 Likes
on
0 Posts
Originally Posted by LSs1Power
Nice... What kind of injectors are you running?
Im going with the Cobalt 2.5 bar sensor. Im never going to go over 22-23psi.
Im going with the Cobalt 2.5 bar sensor. Im never going to go over 22-23psi.