HUNTER02SS

iTrader: (24)

I tried putting on the stock rocker arm setup and the bar that the rocker's sit on doe's not sit flat. Tha little tab's on each end of the bar do not fit correctly. Is it ok to grind them off or do I need to get aftermarket rocker arms.thank's for the help.

Sigforty

Grind them, they are only there to help the rockers sit in place during the assembly line production.

vettenuts

iTrader: (4)

One other option I looked at was the LPE steel support, it is flat and much stronger. In the end I went with Cranes though so I didn't bother.

Good luck with the heads, what you are putting in for a cam?

HUNTER02SS

iTrader: (24)

Thanks for the help guy's.