Re-sealing the PCM connectors
#1
Re-sealing the PCM connectors
I know that a lot of people remove the un-used wires in their harness when they do the conversion, but what is everyone doing to seal up the connector where the wire used to pass through?
I left all the wires in my PCM connectors so it wasn`t an issue for me, but I was curious what everyone else was doing, leaving a couple inches of wire in the connector? Filling the empty spots with silicone/epoxy? Buying new connectors or rubber seals?
I left all the wires in my PCM connectors so it wasn`t an issue for me, but I was curious what everyone else was doing, leaving a couple inches of wire in the connector? Filling the empty spots with silicone/epoxy? Buying new connectors or rubber seals?