Anybody have experience with these Mods
#1
Anybody have experience with these Mods
I am planning on doing the following mods:
224/224 Lunati Ground Cam
• LS2 Hydraulic Roller Lifters
• Adjustable Timing Chain
• Comp Valve Springs
• LS6 Ported Oil Pump
• Ported LS1 Heads
• LS6/Z06 Intake
• Ported Throttle Body
• SLP Lid
• SLP Smooth Bellow
• K&N Filter
• LSP MAF
• Stainless Steel Long Tube Headers
• Off-Road “Y” Pipe
• SLP Loud Mouth Cat-BaCK
I will also be getting a tune and I know HP and TQ will be affected by the quality of the head porting.
I was wondering if anybody knew what I could expect for rwhp and torque. Both the best case scenario and the worst case scenarion.
Any input is much appreciated.
224/224 Lunati Ground Cam
• LS2 Hydraulic Roller Lifters
• Adjustable Timing Chain
• Comp Valve Springs
• LS6 Ported Oil Pump
• Ported LS1 Heads
• LS6/Z06 Intake
• Ported Throttle Body
• SLP Lid
• SLP Smooth Bellow
• K&N Filter
• LSP MAF
• Stainless Steel Long Tube Headers
• Off-Road “Y” Pipe
• SLP Loud Mouth Cat-BaCK
I will also be getting a tune and I know HP and TQ will be affected by the quality of the head porting.
I was wondering if anybody knew what I could expect for rwhp and torque. Both the best case scenario and the worst case scenarion.
Any input is much appreciated.
#2
12 Second Club
Join Date: Mar 2003
Location: jonesville, MI
Posts: 334
Likes: 0
Received 0 Likes
on
0 Posts
I would say that the bellows, MAF sensor, and LS2 lifters would be a waste of money. Power output will depend on cam LSA/advance/lift too. You could probably put down around 400 RWHP and maybe 375 RWTQ with the right setup (that may be a bit optimistic).
#3
12 Second Club
Join Date: Jul 2006
Location: Pittsburgh,PA
Posts: 799
Likes: 0
Received 0 Likes
on
0 Posts
i agree with 01redws6 i dont think 400/375 is out of reach at all...if its an m6 car, it might be a possibility to see 4xx/4xx. make sure to keep us updated though man, sounds like it should run pretty strong