t56 problems
#1
Launching!
Thread Starter
iTrader: (14)
Join Date: Aug 2006
Location: Richmond, TX
Posts: 213
Likes: 0
Received 0 Likes
on
0 Posts
t56 problems
im doing a 4l60e to t56 swap on a 99 silverado 4.8. i get everything lined up. the tranny slides in fine and hits a stop. the dow pins arent even touching yet but it is bottomed out. i tried to tighten it down and broke a bolt hole. the flywheel wont budge when i tighten the tranny bolts either. any suggestions?
any help is greatly appreciated.
if i cant get it today im takin it somewhere and havin it done. its a pita without a lift
any help is greatly appreciated.
if i cant get it today im takin it somewhere and havin it done. its a pita without a lift
#3
Launching!
Thread Starter
iTrader: (14)
Join Date: Aug 2006
Location: Richmond, TX
Posts: 213
Likes: 0
Received 0 Likes
on
0 Posts
yea i pulled it back and u can see on the input shaft where it pushed in a few inches. i put some lubricant on it and it cleaned it off a few inches so i know it went in that far.