thumpstick

I posted a thread not long ago about supercharging my ls1 rx7. I need the dimensions of the f-body procharger. I'm not sure if there is a difference between the physical dimensions of the p1sc and the d1sc, and I'm not sure which I will be using so I'll need to know the sizes for both . I need to know how far foward it comes (from the front to the alternator pully to the front or the inlet). I could also use the width, but it isn't as important.

thanks,
-John

ChevyChad

iTrader: (50)

The P1SC and D1SC are the exact same size. Only difference is the internals. I don't have a P1 anymore, so I can't help you out on any measurements...

thumpstick

Thanks, I figured that was the case but I wasn't sure.

So, to simplify, would someone with either a P1SC or a D1SC on an fbody mind measuring the length from the front of the alternator pulley to the front of the inlet?

Thanks again

thumpstick

will someone help me out here?

EPP

iTrader: (22)

My car is currently up on one of our lifts, give me a call this morning and I'll get measurements for you. 260 244-4808. Bob