ECS hooked me up!
#1
TECH Regular
Thread Starter
Join Date: Nov 2006
Location: Westampton, NJ
Posts: 444
Likes: 0
Received 0 Likes
on
0 Posts
ECS hooked me up!
Just wanted to say thanks to ECS for a job well done. I decided to take the car to East coast supercharging for a dyno tune after i learned about their new Dyno pack dyno. Doug did a great job on the car and was able to pull out some impressive numbers considering its not exactly an ego boosting dyno. ended up with 417 horse and 404 tq. Now the car had run 11.73 back in october in a negative DA, and i wanted to see where the car was since the installation of my new "Mamofied" fast 90/90, so i took the car right from the dyno to the track and ended up with an 11.67 @ 119.03 spinning to a 1.71 60. Its an M6 car with an LS7 clutch and 3.91 gears, and i run MT ET streets.
Heres the graphs:
Mods are in my sig btw
Heres the graphs:
Mods are in my sig btw
#3
TECH Regular
Thread Starter
Join Date: Nov 2006
Location: Westampton, NJ
Posts: 444
Likes: 0
Received 0 Likes
on
0 Posts
i dunno i would assume they are...east coast supercharging is the name of the shop. if they arent a sponsor here then they are over on corvette forums. 90% f the cars parked out front were corvettes with prochargers on them, and they've build some nasty cars in the past.
#4
TECH Addict
iTrader: (35)
Join Date: Dec 2005
Location: Cherry Hill, NJ
Posts: 2,373
Likes: 0
Received 0 Likes
on
0 Posts
Well, you definitely picked up 20+rwhp/.2+ tenths at the track (if the conditions are the same.) Considering the car went a tenth quicker in 75degree air than your previous PB of 11.7 in dense 40 degree air. In that same air with traction an 11.40 is definitely possible