LS1TECH - Camaro and Firebird Forum Discussion

Generation III External Engine LS1 | LS6 | Bolt-Ons | Intakes | Exhaust | Ignition | Accessories
Sponsored by:
Sponsored by:

Prothane/Clamshell install help

Thread Tools
 
Search this Thread
 
Old 06-06-2008, 10:57 PM
  #1  
On The Tree
Thread Starter
iTrader: (5)
 
FadedFD's Avatar
 
Join Date: Feb 2008
Posts: 144
Likes: 0
Received 0 Likes on 0 Posts
Default Prothane/Clamshell install help
Before I tighten the bolt and screw down, I just wanted to make sure that the washer is in the correct place. I lost my instructions and just sorta figured out how the bushing goes in but am not sure about where the washer goes. Can someone confirm before I tighten and it eats into the powder coating? Thanks dudes



FadedFD is offline  
Reply Like
Old 06-07-2008, 03:44 AM
  #2  
TECH Addict
iTrader: (2)
 
35th SS's Avatar
 
Join Date: Dec 2001
Location: Hawaii track track.
Posts: 2,622
Likes: 0
Received 1 Like on 1 Post

Default
had mine on the opposite side.looks like you got the tabs on the correct side also.good luck.
35th SS is offline  
Reply Like
Old 06-07-2008, 10:03 AM
  #3  
On The Tree
Thread Starter
iTrader: (5)
 
FadedFD's Avatar
 
Join Date: Feb 2008
Posts: 144
Likes: 0
Received 0 Likes on 0 Posts
Default
So do I need to put the washers on the back side of the clam shells? Or did you mean you had the bolts facing the other way? Thanks.
FadedFD is offline  
Reply Like
Old 06-07-2008, 10:17 AM
  #4  
TECH Addict
iTrader: (2)
 
35th SS's Avatar
 
Join Date: Dec 2001
Location: Hawaii track track.
Posts: 2,622
Likes: 0
Received 1 Like on 1 Post

Default
your bolts are correct.I mean washers on the back side of the clamshell.pretty looking powdercoat btw.
35th SS is offline  
Reply Like
Back to Subforum
Generation III External Engine
View Next Unread
whats the easiest way to do an oil pan gasket and motor mounts???




Advanced Search

All times are GMT -5. The time now is 12:58 PM.