has anyone built their own 3.5-4" mufflex?
#2
TECH Resident
Join Date: Jan 2003
Location: South Alabama
Posts: 937
Likes: 0
Received 0 Likes
on
0 Posts
I bought QTP headers and metallic cats and had my Y pipe custom made with the Magnaflow dual 3" into single 3.5" with a reducer back to 3". The p/n for the merge was
Y300350 (bought at Thunder Racing I believe). Problem was the exhaust people around south Alabanana were either too lazy or too stupid because it just didn't ever fit right even after I tried to have it repaired on 2 other occasions.
I gave up and got ARH headers with catted y and have never looked back.
Y300350 (bought at Thunder Racing I believe). Problem was the exhaust people around south Alabanana were either too lazy or too stupid because it just didn't ever fit right even after I tried to have it repaired on 2 other occasions.
I gave up and got ARH headers with catted y and have never looked back.
#5
12 Second Club
iTrader: (4)
I made my own 4" single exhaust with a flomaster merge and went to a truck parts shop for the tubing and bends. Got a few pre bent pieces and staight pipe, put 12" sweetthunders at rear of car inside some nice tips. Switched it out for duals for now. had plenty of ground clearance with the 4" over the axle,was tight by the PHB brace but it fit.