Need help figuring out wiring on older FJO 908 RPM WINDOW SWITCH
#1
TECH Enthusiast
Thread Starter
Join Date: Feb 2007
Location: FL
Posts: 650
Likes: 0
Received 0 Likes
on
0 Posts
Need help figuring out wiring on older FJO 908 RPM WINDOW SWITCH
Well I seem to have bought an older model and the wiring diagram on the fjo site is only for their new one. mine only has 5 wires instead of six.
If someone could just tell me if I am right or not that would be a huge help.
wires are:
Black- ground
Red- power
green- tach signal
and two white wires, I am assuming one for each stage.
Can anyone confirm this for me?
Thanks,
Steve
If someone could just tell me if I am right or not that would be a huge help.
wires are:
Black- ground
Red- power
green- tach signal
and two white wires, I am assuming one for each stage.
Can anyone confirm this for me?
Thanks,
Steve
#4
TECH Fanatic
iTrader: (1)
Join Date: Mar 2004
Location: Southern NH
Posts: 1,644
Likes: 0
Received 0 Likes
on
0 Posts
white-power
blk-ground
yellow-stg1
orange-stg2
blue-tps
grn-rpm
Take a look at these instructions:
http://www.zex.com/Base/Instructions/ZEX169.pdf
#5
TECH Enthusiast
Thread Starter
Join Date: Feb 2007
Location: FL
Posts: 650
Likes: 0
Received 0 Likes
on
0 Posts
Yes I looked at those.
Here is what it says on the bottom of my window switch:
"CWS0908 SER#1100 908 Window Switch, Dual Channel"
That is what is confusing me.
Thank you very much for the help.
Here is what it says on the bottom of my window switch:
"CWS0908 SER#1100 908 Window Switch, Dual Channel"
That is what is confusing me.
Thank you very much for the help.
#6
TECH Enthusiast
Thread Starter
Join Date: Feb 2007
Location: FL
Posts: 650
Likes: 0
Received 0 Likes
on
0 Posts
From looking at the wiring diagrams I see that does have the correct corresponding wires.
My last question is, does it matter which of the white wires goes to either the wot switch or the relay?
My last question is, does it matter which of the white wires goes to either the wot switch or the relay?