need lots of help! opti install issues
#1
need lots of help! opti install issues
so i just put in a new opti. 8.8mm taylor wires, and underdrive pulleys.
but now i have porblems, there is a tick on the drivers side and it kinda sounds like an eletrical arc'ing but all my plug wires are on tight. also its stumbling all over it self from about 900-4000k rpm's. also the alt seems like its not keeping up (the story on that is that i damaged some of the groves on the crank pulley and so rather than replace the very expensive balancer i just put underdrive pulleys on) so my z has been down about two weeks and i really need help getting it going.
but now i have porblems, there is a tick on the drivers side and it kinda sounds like an eletrical arc'ing but all my plug wires are on tight. also its stumbling all over it self from about 900-4000k rpm's. also the alt seems like its not keeping up (the story on that is that i damaged some of the groves on the crank pulley and so rather than replace the very expensive balancer i just put underdrive pulleys on) so my z has been down about two weeks and i really need help getting it going.
#2
FormerVendor
Join Date: Jan 2002
Location: Mpls., MN
Posts: 173
Likes: 0
Received 0 Likes
on
0 Posts
For starters, throw away the Taylor wires and install a set of MSD's (wires being one of the few things MSD seems to make right). I have seen too many Taylor wires cause endless problems right out of the box.
#4
TECH Fanatic
iTrader: (10)
so i just put in a new opti. 8.8mm taylor wires, and underdrive pulleys.
but now i have porblems, there is a tick on the drivers side and it kinda sounds like an eletrical arc'ing but all my plug wires are on tight. also its stumbling all over it self from about 900-4000k rpm's. also the alt seems like its not keeping up (the story on that is that i damaged some of the groves on the crank pulley and so rather than replace the very expensive balancer i just put underdrive pulleys on) so my z has been down about two weeks and i really need help getting it going.
but now i have porblems, there is a tick on the drivers side and it kinda sounds like an eletrical arc'ing but all my plug wires are on tight. also its stumbling all over it self from about 900-4000k rpm's. also the alt seems like its not keeping up (the story on that is that i damaged some of the groves on the crank pulley and so rather than replace the very expensive balancer i just put underdrive pulleys on) so my z has been down about two weeks and i really need help getting it going.