View Full Version : Where to get 1/2" head studs


'Trust'
10-04-2008, 03:33 PM
Does anyone know where I can get 1/2" head studs? I'd like to get some ASAP.

v8pwr
10-04-2008, 04:56 PM
Wheel 2 Wheel

Beaflag VonRathburg
10-04-2008, 05:13 PM
Wheel 2 Wheel no longer exists. You should be able to get them through engine builders like Erik Koenig, Weber, LME, etc... Look for shops that build a lot of high end race car stuff like Stenod, LMR, etc... Just call around. Keep in mind that you're going to have the block and heads machined to accept that large of a stud. You could also use L19 head studs which have right around the same clamping force.

'Trust'
10-04-2008, 07:21 PM
I'm also an idiot because I meant Gen III internal engine, not Gen IV. Whoops. I think I found a place though. Thanks Beaflag!

Phil99vette
10-04-2008, 07:23 PM
PM 427 AKA Kurt Urban

Tom@SpeedInc
10-05-2008, 06:19 PM
I can get a 1/2" head stud kit that are ARP 2000 material

took a bit of reaserch to find these ;)

v8pwr
10-07-2008, 07:02 PM
I work too much . What happend to W2W ? I'm kind of shocked to hear that . Is there a story on this I can look up .

Juiced
10-10-2008, 04:40 PM
I work too much . What happend to W2W ? I'm kind of shocked to hear that . Is there a story on this I can look up .

Quantum Tecstar the Parent Company shut the doors due to the Economy, it had nothing to do with Customer Service.