Rob94hawk

iTrader: (1)

I've got this diagram but what I can't find at the moment are the bolts and I believe I tossed them due to corrosion. If someone can kindly tell me what they are I'll just take another trip to ACE hardware for the 20th time...

RamAir95TA

iTrader: (2)

Which ones do you need? Or all of them?

96TransAmboosted

iTrader: (8)

Next time hot them with a wire wheel and some paint and you will be all good.

Rob94hawk

iTrader: (1)

All 4 of them.

SS RRR

iTrader: (2)

The manual I have says 3/8-16X2.50. There are only three bolts that hold the bracket in place. Do you need the fourth that holds the spark plug support?

Rob94hawk

iTrader: (1)

Yes I do since that goes into the block as well. But there are 2 different sizes. The two up top are shorter than the ones on the bottom. Correct?

SS RRR

iTrader: (2)

I don't think so? I believe all three sizes are the same. I'll have to get back to you on that. Don't have the manual handy right now.

SS RRR

iTrader: (2)

There are at least 3 bolts that are 3/8X16X2.50 and one that is 3/8X16X1.12. At least as far as I can tell.

Spartan7

iTrader: (7)

The top two going into the head are shorter than the other 2. Then there's a slightly longer one under the tensioner, and the longest one that holds the spark plug bracket. They are all the same pitch, 3/8-16, just different lengths.

SS RRR

iTrader: (2)

Yeah I probably read it wrong. If I were to guess I would say the two that go into the head are 1.12" and the bottom two are 2.5".