chevylt1camaro

i have a Hurt Shifter Line Loc that is not workin i do believe it engages unsure though any suggestions?

lt1slowz28

turn on line lock, push pedal to floor, hold button, release pedal...



if not check the wiring.

chevylt1camaro

ok then i have it wired wrong the instalation instructions are a bit confusing, i have a push button that is an on off switch which i believe to be the button to " Turn On" the Line loc then there is an actuall button like device that is not mentioned in the instructions. where would i wire that into?

chevylt1camaro

think i got it figured out will try the new setup tomorrow

lt1slowz28

you wire the on off toggle inline closer to the solenoid than the button, so when it is off the button will do nothing.

chevylt1camaro

got it working thanks