Coders11

iTrader: (1)

what are you guys with pacesetter LTs using for a Y....I got the pacesetter one that SE's site said would fit but it angles up like the stock piece did and wont fit on the LTs. The car is a 95 TA...thanks for the help.

Camaro94SS

I just bought pacesetter LTs from TSP and i bought the pacesetter ORY with them....havent began the install. Everything is just sitting in my living room and going on this thursday...

Coders11

iTrader: (1)

I have the pacesetter ory but it wont even come close to fitting the catback and headers.

Camaro94SS

Well the ORY doesnt have a cat...and the stock Y had a cat...that was a good foot of pipe gone right there...that is probably why its not fitting....i ordered a cutout with my LTs and ORy also....hopefully the cutout will replace the cat length....ill see though

AJ52486

I think that they are the same size whether or not they have the cat. Pacesetter makes mid-length headers, is it possible that you have the Y for those?

Camaro94SS

uuuh, yeah theyre the same size as the stock one,but the stock Y has a cat in addition to the standard size...

the_merv

iTrader: (88)

Are you guys saying you are haying problems getting the Pace Setter Y-pipe onto the Headers? I am putting on the LT Headers, the Y-pipe, then the Cat, and it's running into my Dynomax Bullet dropping infront of the Rear Axle. I already looked at it, and didn't see any problems...

Camaro94SS

well i havent started yet, but im putting on pacesetter LTs, ORY, and a cutout with no cats...i know that the cat after the Y is a good foot of pipe,and i think thats where hes coming short....but im putting on a cutout, so hopefully im not short any pipe...

the_merv

iTrader: (88)

You can always get a little 16" extention piece on it at Autozone or somewhere like that, it will probably cost around $5.00..