Input shafts for T65
#1
Input shafts for T65
Alright bought a T56 out of a cobra and I think I can make this work with an LS motor. The input shaft that is in the tranny now is a 26 spline (came from an aston martin or a viper). I think it may be a little long though. I can have it machined to the correct length and pilot bearing size if I knew exactly what those were for an LS motor. If anyone can help me with these measurements ,as I dont have the engine or a LS T56 input shaft to take measurements from, all I should need is a bellhousing and I would be good to go.