Need some help with my hydraulics
#1
Staging Lane
Thread Starter
Join Date: Jun 2004
Location: New Jersey
Posts: 62
Likes: 0
Received 0 Likes
on
0 Posts
Need some help with my hydraulics
MY clutch isnt operating properly and the the hydraulic fluid is really dark gray. I have a mity vac. If someone could just point me in the direction of where to find the bleeder valve so i can flush out mall the crud that would be great.
#2
wrencher
iTrader: (2)
There is a bleeder on the drivers side of the trans. It is just above the slave cylinder line. It is a 7/16 or 11 mm hex.
You use the 90 degree cone adaptor for the mighty vac & put it in the bleeder hole w/ it just barely cracked.
Make sure you keep the reservoir full when you bleed it.
You use the 90 degree cone adaptor for the mighty vac & put it in the bleeder hole w/ it just barely cracked.
Make sure you keep the reservoir full when you bleed it.
Last edited by wrencher; 08-26-2005 at 09:04 PM. Reason: typo