Instructions of doing bump stop mod with volt-meter, not autotap?
#1
Instructions of doing bump stop mod with volt-meter, not autotap?
I am looking for instructions on doing the bump stop mod measuring the voltage to get close to 90 degrees, 4.65v is what most recommend if I remember correctly. I know I just file down the stopper slowly to allow the blade to open more, but I do not know how I go about measuring the volt-readout that tells me how close I am to 90.
I read this:
https://ls1tech.com/forums/showthrea...hlight=writeup
But am getting a reading of 5.01V when the pedal is at WOT, however my car is stock, and I don't get any codes.
I read this:
https://ls1tech.com/forums/showthrea...hlight=writeup
But am getting a reading of 5.01V when the pedal is at WOT, however my car is stock, and I don't get any codes.
Last edited by cascadesys; 06-11-2008 at 08:49 PM.