Strange Electrical problems (cags,maf,oil press)
07-12-2010, 06:02 PM
#1
11 Second Club
Thread Starter
iTrader: (14)
Join Date: Nov 2004
Location: Michigan (Macomb or Lansing)
Posts: 1,653
Likes: 0
Received 0 Likes
on
0 Posts
Strange Electrical problems (cags,maf,oil press) I recently changed a valvespring and did a break job. I don't think i affected anything electrically, however I am having a few problems.
My oil pressure gauge was reading very erratically and hopping all over the place. I wiggled the wires, checked connections, and it works fine again.
Now I am noticing that my CAGS is messed up. Reverse lockout is always on, and my maf sensor reads 0 hz. I will try another maf sensor when i get a chance but it seems like something is going on for all three of these things to act up at the same time.
Does anyone have any ideas? The only thing i can think of is that maybe i snagged a wire or two when putting my coil packs/valve covers back on but I think that is very unlikely.
My oil pressure gauge was reading very erratically and hopping all over the place. I wiggled the wires, checked connections, and it works fine again.
Now I am noticing that my CAGS is messed up. Reverse lockout is always on, and my maf sensor reads 0 hz. I will try another maf sensor when i get a chance but it seems like something is going on for all three of these things to act up at the same time.
Does anyone have any ideas? The only thing i can think of is that maybe i snagged a wire or two when putting my coil packs/valve covers back on but I think that is very unlikely.
