Roman nj.

My predator tuner cannot read the vehicle type(1). I messed somthing up by turning on my AC while doing a live data log. It was hot! As soon as I turned the AC on the tuner went dark and my dash cluster beeped and flashed like when loading a tune. I unplugged it and turned the car off. The tuner comes on when I plug it in and when it prompts me to turn the ignition to the on position it says it can't read the vehicle type(1). It also will not read trouble codes etc. I checked the fuses under the dash and on the passenger side under the hood and none where blown. can anyone help? Thanks

green96ta

iTrader: (11)

did you check the pcm ignition fuse?

Roman nj.

there's an ignition switch fuse is that the one your talking about. i did not check it.

Roman nj.

checked it, not blown.

99ws6ls1

i know that it wont read the car if there are stored codes. even if you cant read them try to clear them and try again

Mike@Diablosport

iTrader: (2)

Try disconnecting the battery for a minute.

Roman nj.

disconnected battery for about two hours and still nothing.

JRENIGAR

iTrader: (37)

turn key to on position before plugging it it to the dash. My predator tuner had this problem and wouldnt link up to the car any other way... ???

Roman nj.

Hooked my buddies scanner up and that reads the computer. It must be my predator. Anyone one know how much diablo charges for repairs?

06MonteSS

if it's not within the 2 year warranty, then it'd be $99 I believe, but not 100% sure...

contact diablo tomorrow.. 9am - 5:30pm eastern time...