corpserodeo666

iTrader: (12)

This has been a massive problem with these damn coils! I have been using the coils they sold. Then I come to find out that it won't matter because of the firmware being not supported from the 1st gen Dominator units. I swapped to truck coils, everything was going fine for a few weeks at about 22lbs. Went up to about 24 and blew the unit.

I NEED TO GET ONE ASAP. DOES ANYONE HAVE A NUMBER OR A PERSON I CAN CALL TO GET IT ASAP! ROBYN?

Mike@Diablosport

iTrader: (2)

So, adding 2 psi caused the coils to kill the ECU? Is that what you are saying?

corpserodeo666

iTrader: (12)

Yep. I looked over the whole car and I guess the back feed is real bad on the Gen 1 units and it fried my ECU. I was one of the 1st ones to get this Holley Dominator platform when they 1st introduced it. Has been great until now.

corpserodeo666

iTrader: (12)

Well.. After an hour and a half on hold with Holley support! I am shipping the unit to Holley to get fixed/ upgraded. Supposedly I will have it back in my hands in the next few days. FYI if anyone is looking to buy a new unit they are on BO from Holley.