Corsa or magnaflow 3" comp series
#1
Corsa or magnaflow 3" comp series
Hey guys I was wondering what you think i should get,corsa sport or magnaflow 3" comp series..current set up on my 06: zL402 block with forged internals,texas speed 228r cam,799 heads,professional products ported polished 96mm intake,kooks long tube headers with catted mids,spintec exhaust with x pipe,Ati procharger,2400 stall,60lbs injecters,3:91 gears,driveshaft shop single peice aluminum drive shaft,stage 5 trans,pedders rear suspension..was wondering what you guys think would be a better exaust for the car?
#3
The Magnaflow section that is 2.5" is like an inch long....
If you're over the 550 rwhp mark, I'd go 3". Here is a pic of my magnaflow x pipe that I removed. Just went a different route in the middle of the car and used the ARH x pipe off of 2" headers.
If you're over the 550 rwhp mark, I'd go 3". Here is a pic of my magnaflow x pipe that I removed. Just went a different route in the middle of the car and used the ARH x pipe off of 2" headers.
#4
#5
TECH Enthusiast
iTrader: (1)
No 3" with them. I was told by them it wasn't needed even at the 1000hp mark because of their muffler design. I laughed at them and went another route. BORLA makes a nice kit and it fits right. I one had a kooks 3" kit, but it fit terrible and the bends weren't given much thought so I dumped it.