Category: Wheels & Tires
Price: $1000
Part Fits: 93-02 Chevrolet Camaro, 93-02 Pontiac Firebird
Location (State): TX
Item Condition: Used
Shipping Information: Item Can be Shipped
LS Engine?: Fits LS Engine

SOLD REDUCED PRICE Selling one of two sets of Bogart P1 Welded GT lightweight racing wheels. Will include 4 Billet aluminum center caps with engraved logo, no lugs or washers. This set is near new condition, 3 years old. Wheels built for 4th Gen F-Body with narrowed rear 2.5 to 3.0 inches. Bolt pattern 5x4.75"
Fronts: 15x4 with 1.75" backspacing
Rears: 15x9.75 with 5.375 backspacing

Why wait several weeks to have a set built when you can have these next week at half the cost.

$1000.00
Slicks not included

 

back up

 

how well would these fit on a non-narrowed rear?

 

They will stick out 2.5" - 3.0" further than your stock wheels. So they will probably hit your fenders on bumps if not always.

Very nice set of wheels! I wish they were for a stock width rear.

 

back up

 

these will also fit a stock 1st-3rd gen rear FYI.

 

to the top

 

Can you get a pic of one mounted on a stock width rear? I may just suck it up if they aren't that bad.

 

Dude it would look ricer sticking a full 2.5 inches further out than in the pic above. I seriously doubt you could suck it up unless your into that kinda look!!

 

You are probably right. I was just trying to compare them to the typical Convo Pro or Warriors which tend to stick out a little also.

 

back up

 

What part of TX? My rear is narrowed 2.5 and I got cash in hand.

 

30 minutes south of Dallas in Waxahachie

 

My next day off is Wednesday. I'm in s'port. Anyway we could meet halfway?

 

I work M-F and have a wedding to attend this weekend. You can come tomorrow on your day off, I'll be at the house by 5pm

 

Sold!!!