TSP CNC LS3/L92 68CC 15k miles Stainless intake Valves

Reply Subscribe

Thread Tools

Search this Thread

Feb 14, 2014 | 09:59 PM

CamaroRick

Thread Starter

11 Second Club

iTrader: (24)

Joined: Jan 2005

Posts: 362

Likes: 2

From: Maryland

TSP CNC LS3/L92 68CC 15k miles Stainless intake Valves

Category: Accessories
Price: $720
Part Fits: 2010+ Camaro, 93-02 Chevrolet Camaro, 93-02 Pontiac Firebird, Corvette, 04-06 Pontiac GTO, 04+ Cadillac CTS-V
Location (State): MD
Item Condition: Used
Shipping Information: Item Can be Shipped
Engine: LS2/LS3/LS7/L92/LS9
LS Engine?: Fits LS Engine

SOLD

I have my Texas Speed CNC ported 68cc camber heads for sale. I bought them with the stainless valve upgrade. I paid close to $1900 for them a few years ago. I put almost 10,000 miles on them on my 408 motor. 1 intake valve dropped and touched a piston, the guide was in tollerance so I got a replacement valve from TSP.

I bought a set of hollow stem valves to run due to running a way too big of a cam for ls3 heads and ran them a while. I used a .030" headgasket and the short skirt (old design) pistons would rock in the over honed bore and made skuff marks on the heads (need to be milled) I sold the hollow stem valves and the stainless exhaust valves with the springs. Still have the original Stainless intake valves Cleaned up to go with the heads (+the 1 replacement)

Im looking to 720 for them plus shipping. let me know if you have any questions.
Shipping is going to cost $50-$75 we can call it $50 so $770 shipped or $720 picked up

Last edited by CamaroRick; Feb 21, 2014 at 12:23 PM.

Feb 14, 2014 | 10:11 PM

CamaroRick

Thread Starter

11 Second Club

iTrader: (24)

Joined: Jan 2005

Posts: 362

Likes: 2

From: Maryland

Pics Scroll right
http://s1142.photobucket.com/user/Ca...4_039.jpg.html

Feb 15, 2014 | 11:17 PM

CamaroRick

Thread Starter

11 Second Club

iTrader: (24)

Joined: Jan 2005

Posts: 362

Likes: 2

From: Maryland

PMS sent if the pics Dont work for you u can see them on my clist add here
http://baltimore.craigslist.org/pts/4334164329.html

Feb 15, 2014 | 11:34 PM

Longrodlx

Teching In

iTrader: (1)

Joined: Apr 2011

Posts: 27

Likes: 0

From: Earth

Damn that's a good deal

Feb 16, 2014 | 07:14 PM

CamaroRick

Thread Starter

11 Second Club

iTrader: (24)

Joined: Jan 2005

Posts: 362

Likes: 2

From: Maryland

The heads can be installed as is, It is more of a cosmetic thing u can see in the pictures up close on the chambers, the exhaust side where it is clean on the piston end. I am only saying to mill them as a precaution.