I doubt that I'll get much of a response on this site for this stuff...but it's worth a try

Pics available on request, paypal accecpted nocturnalz28@gmail.com

LT1 stuff:

***Nitrous Work Plate. (plate only)
Retails from Jegs for $152.99
This one is in perfect working order, I just need one with 58mm openings and this one only 52mm openings.

$85

***LT1 cast iron heads. Came off of a 96 Impala SS. Nice condition, no valves or springs.

$75

***Stock LT1 timing chain. GM part. New in plastic, never been opened.

$20

***Stock exhaust tips from a 1996 WS6

$30

***Stock LT1 rods and pistons. They have some miles on them, but no defects. Only selling them because I switched to forged internals.

$50

***REV valves, 2.00 intake, 1.57 exhaust, stock LT1 length. These were installed, but not ran because I needed .100 longer than stock valves and didn't realize it until these were already installed so my loss is your gain. My new valves are ferreas, so these are in a ferrea box, but trust me they are REVs.

$75 SOLD!!!

***Stock 92-95 LT1 crank hub. Freshly bead blasted and ready to ship.

$35

***Stock shifter for M6, nuff said

$20

3rd gen stuff:

***Non A/C heater box (1LE heater box) This was a pain to find, and I sold my 3rd gen before I got to install it. It's been freshly painted black and comes with a blower motor, resistor, and hardware.

$100

***Luggage compartment roll-up cover. Black vinyl. Nice condition, but not 100% perfect.

$40

Stuff that I need:

If you have any of these parts that you wanna get rid of, let me know. I'd be willing to work out a trade also if you're interested in any of the above...

---Rear calipers both left and right for a 93-97 f-body

---Left rear taillight for a 93-96 camaro

---LT1 (or LT4) starter motor

---96-97 camaro SS spoiler

 

Will the nitrous plate work with the stock lt1 throttle body?

 

Yes, infact I was using it with a stock throttle body on my old motor

 

Would you be willing to sell the blower motor seperate?

Sara Lou

 

I would rather keep it complete, but if that changes I'll let you know

 

Ok thanks, BTW, how much for the roll-up cover?

Sara Lou

 

If you can wait 30 days on the LT1 calipers, I will be changing out mine on my 3rd gen to the willwood setup and I'll ship 'em to ya in trade for the 3rd gen roll-up cover.

 

I'll do $40 shipped on the cover

 

I bought LS1 style backing plates and calipers yesterday local for $35. I couldn't pass them up for that price, so I'm gonna convert my rears over to those. But thanks for the offer And as mentioned above, I'll do $40 shipped for the cover if you're still interested...

 

 

One last bump...