Garage sale CCWs, C5 Parts, Camaro Parts, etc..
Thread Starter
TECH Regular
iTrader: (18)
Joined: Aug 2005
Posts: 492
Likes: 1
From: Quakertown PA 18951
My father told me I have too much junk laying around the barn and shop at his house. Time to clean it up. This stuff is up for sale cheap, but I'm always open to offers. Just don't insult me with a ridiculous lowball offer.
Black CCW drag pack for C5s. SOLD
SLP bowtie grill. SOLD
Edelbrock non adjustable tubular panhard bar. Used. Fair condition. One grease zerk won’t take grease so it should be replaced. $55 shipped.


LS truck flexplate. No cracks. From a wrecked 2002 GMC with a 5.3L engine.

Stock frame pads and motor mounts from a 99 Trans Am. They look to be in good condition. $35 shipped.


(2) Sets of 6.0L truck manifolds. No broken studs. One set with heat shields, one with out. $45 shipped for the pair without shields, $50 shipped with shields.


New polished aluminum trans pan for a 4L60E. I think it fits 700R4 transmissions too, but I’m not 100% sure. It has a drain plug and it holds one extra quart of trans fluid. Brand new, still shiny. $50 shipped.


Stock Y pipe off my 2001 Camaro (LS1) $40 shipped

Stock torque arm. Looks fine to me. $40 shipped.

Black CCW drag pack for C5s. SOLD
SLP bowtie grill. SOLD
Edelbrock non adjustable tubular panhard bar. Used. Fair condition. One grease zerk won’t take grease so it should be replaced. $55 shipped.


LS truck flexplate. No cracks. From a wrecked 2002 GMC with a 5.3L engine.

Stock frame pads and motor mounts from a 99 Trans Am. They look to be in good condition. $35 shipped.


(2) Sets of 6.0L truck manifolds. No broken studs. One set with heat shields, one with out. $45 shipped for the pair without shields, $50 shipped with shields.


New polished aluminum trans pan for a 4L60E. I think it fits 700R4 transmissions too, but I’m not 100% sure. It has a drain plug and it holds one extra quart of trans fluid. Brand new, still shiny. $50 shipped.


Stock Y pipe off my 2001 Camaro (LS1) $40 shipped

Stock torque arm. Looks fine to me. $40 shipped.

Last edited by Zger; Dec 6, 2007 at 01:35 PM.
Thread Starter
TECH Regular
iTrader: (18)
Joined: Aug 2005
Posts: 492
Likes: 1
From: Quakertown PA 18951
LT1 intake manifold. Condition unknown. From a 95 Caprice. $35 shipped.

Stock lid. OK shape. $20 shipped.

Stock LS1 intake manifold off my C5. SOLD
Stock C5 shifter and ****. 70k miles on each. $25 shipped.

Stock “CAMARO” grill. $25 shipped.

3.5” Mufflex cat back. Bought this used, never used it. It’s got a cut out in the I pipe. Single outlet. Your choice of a new stainless Magnaflow muffler that is very large and might not fit, or a used Spintech muffler that definitely fits. I never had this on the car so I don’t know if the Magnaflow will fit under the gas tank for sure or not. It probably will, but I don’t know for sure. This thing is pretty heavy so the shipping won’t be cheap. $300 shipped in the 48 states. $250 picked up.




New Percy’s header gaskets. Came with my old Kooks headers and I used new GM ones instead. Never been out of the package. $20 shipped

New C5 slave cylinder and pilot bearing. Never installed. $110 shipped.


Hooker ceramic coated SBC 1 5/8” headers for 68-74 Nova and 67-69 Camaro. Low miles, some scratches in the ceramic coating but in good shape. $200 shipped.


New foam pads that go under the intake manifold. Never used. $15 shipped.

(6) Rubber O-rings from the intake ports on an intake manifold. Incomplete set. Used. $15 shipped.

Used plastic lifter trays and OEM lifters from a wrecked 2002 GMC pick up with a 5.3L motor. Unknown condition. They look OK. $40 shipped.

(16) stock pushrods from a wrecked 2002 GMC pick up with a 5.3L motor. All are straight. $25 shipped.
Stock aluminum driveshaft with the correct yolk for a Strange 12 bolt. $100 shipped.
Used Magnaflow cat back. Good shape. $300 shipped.

Stock lid. OK shape. $20 shipped.

Stock LS1 intake manifold off my C5. SOLD
Stock C5 shifter and ****. 70k miles on each. $25 shipped.

Stock “CAMARO” grill. $25 shipped.

3.5” Mufflex cat back. Bought this used, never used it. It’s got a cut out in the I pipe. Single outlet. Your choice of a new stainless Magnaflow muffler that is very large and might not fit, or a used Spintech muffler that definitely fits. I never had this on the car so I don’t know if the Magnaflow will fit under the gas tank for sure or not. It probably will, but I don’t know for sure. This thing is pretty heavy so the shipping won’t be cheap. $300 shipped in the 48 states. $250 picked up.




New Percy’s header gaskets. Came with my old Kooks headers and I used new GM ones instead. Never been out of the package. $20 shipped

New C5 slave cylinder and pilot bearing. Never installed. $110 shipped.


Hooker ceramic coated SBC 1 5/8” headers for 68-74 Nova and 67-69 Camaro. Low miles, some scratches in the ceramic coating but in good shape. $200 shipped.


New foam pads that go under the intake manifold. Never used. $15 shipped.

(6) Rubber O-rings from the intake ports on an intake manifold. Incomplete set. Used. $15 shipped.

Used plastic lifter trays and OEM lifters from a wrecked 2002 GMC pick up with a 5.3L motor. Unknown condition. They look OK. $40 shipped.

(16) stock pushrods from a wrecked 2002 GMC pick up with a 5.3L motor. All are straight. $25 shipped.
Stock aluminum driveshaft with the correct yolk for a Strange 12 bolt. $100 shipped.
Used Magnaflow cat back. Good shape. $300 shipped.
Last edited by Zger; Dec 7, 2007 at 06:51 AM.
Thread Starter
TECH Regular
iTrader: (18)
Joined: Aug 2005
Posts: 492
Likes: 1
From: Quakertown PA 18951
Trending Topics
Thread Starter
TECH Regular
iTrader: (18)
Joined: Aug 2005
Posts: 492
Likes: 1
From: Quakertown PA 18951









