DEI 561T Remote Start
#1
TECH Enthusiast
Thread Starter
iTrader: (16)
Join Date: Jun 2005
Location: San Luis Obispo, CA
Posts: 732
Likes: 0
Received 0 Likes
on
0 Posts
DEI 561T Remote Start
What is the best way to bypass VATs so it is only bypassed when the remote start engages? I have the module from eBay but I don't want to completely disable this function.
Also, does anyone have a good wiring diagram for the ignition switch harness?
Thanks.
Also, does anyone have a good wiring diagram for the ignition switch harness?
Thanks.
#2
Staging Lane
iTrader: (1)
Join Date: Oct 2008
Location: Saskatchewan, Canada
Posts: 76
Likes: 0
Received 0 Likes
on
0 Posts
DPDT relay. Center connections going to the PCM. NC connections going to the connector in the steering column. NO connections going to a resistor (or combination of resistors) that matches the resistor in your key.
Connect the relay coil to the ignition disable output on the starter. [Strongly] consider adding a diode across the coil to protect the starter outputs (1N4001 - 1N4007 family would do).
Connect the relay coil to the ignition disable output on the starter. [Strongly] consider adding a diode across the coil to protect the starter outputs (1N4001 - 1N4007 family would do).