Turn Bulb
12-07-2005, 05:47 PM
#1
Banned
Thread Starter
iTrader: (8)
Join Date: May 2005
Location: 'Merica
Posts: 1,785
Likes: 0
Received 0 Likes
on
0 Posts
Turn Bulb I bought the replacement bulbs but I don't know how to get to them...Is there a writeup? Or does anyone here know how? Thanks!
Btw I tried search already!
Btw I tried search already!
Last edited by LS1 GG; 12-07-2005 at 06:30 PM.
12-07-2005, 07:06 PM
#2
TECH Regular
iTrader: (1)
Join Date: Mar 2004
Location: Tampa, FL
Posts: 451
Likes: 0
Received 0 Likes
on
0 Posts
Well I've changed them many times, it is possible to change it without taking off anything but easier and less time to take off the headlight generally.
What I do is unplug the 2 bulbs from the headlight, then remove the 2(i think) bolts holding the assembly in. After that it's tricky bending/prising to get the headlight assembly out.
After it's out, they are a snap to change and take like 20 seconds to be done with, then just reinsert the headlights, bolt back together, put in the bulbs, and shut the hood
Hope that helps some
What I do is unplug the 2 bulbs from the headlight, then remove the 2(i think) bolts holding the assembly in. After that it's tricky bending/prising to get the headlight assembly out.
After it's out, they are a snap to change and take like 20 seconds to be done with, then just reinsert the headlights, bolt back together, put in the bulbs, and shut the hood
Hope that helps some
12-07-2005, 08:50 PM
#3
12 Second Club
iTrader: (5)
Join Date: Aug 2002
Location: Middleville, Michigan
Posts: 1,789
Likes: 0
Received 0 Likes
on
0 Posts
That's the HARD way to do it. Underneath the front corners there are flaps on each side. I believe there are 2 7mm bolts holding the edge in. Undo those and you can drop the flap down and reach up inside and get to the bulbs.
took him about 20 secs! I guess my blinker problems weren't a bulb now I gotta change a relay
12-08-2005, 08:03 AM
#6
There is no relay for the turn signals. It also isn't the flasher causing the problem unless both sides aren't working. A single flasher runs both sides so if one side works but the other doesn't then it can't be the flasher causing the problem.
If it's just the front signal on one side that isn't working and you've replaced the bulb then check that the bulb socket isn't corroded. That's a fairly common problem.
If it's just the front signal on one side that isn't working and you've replaced the bulb then check that the bulb socket isn't corroded. That's a fairly common problem.
12-13-2005, 02:38 PM
#7
Banned
Thread Starter
iTrader: (8)
Join Date: May 2005
Location: 'Merica
Posts: 1,785
Likes: 0
Received 0 Likes
on
0 Posts
The idiot guy at orielys gave me a drl bulb instead of a turn signal bulb it was small. I went to the zone and they gave me the right one, to bad i'd already replaced the flashed 
Meh it sounds nice though so its alright hehe...
Meh it sounds nice though so its alright hehe...