Dust boot for parking brake lever on backing plate
#1
TECH Enthusiast
Thread Starter
iTrader: (11)
Join Date: Nov 2004
Location: columbus GA
Posts: 688
Likes: 0
Received 0 Likes
on
0 Posts
Dust boot for parking brake lever on backing plate
The dust boots that goes around the arm for the parking brake on the backing plates is shot. Anyone here have that part number handy or know where to find them? How about a part number for tha parking brake pad?
#3
LH: 10434794
RH: 10434795
98-02 without traction control:
LH: 10434796
RH: 10434797
Or the service kit (98-02 without positraction) (one needed for each side, LH and RH): 12454994
Here is a thread about it. https://ls1tech.com/forums/suspensio...4-e-brake.html
Hope that helps.
#6
Save the manuals!
iTrader: (5)
We're going to lock this up as we don't revive these old dinosaurs.
This boot has been discussed before in several threads. It is not an exact replacement and will tear: https://ls1tech.com/forums/suspensio...-push-rod.html
So far, the only durable solutions we have found are FirstYrLS1Z making a rubber plate out of a more durable material (in link) or using an old stand-by; rubber nipples: https://ls1tech.com/forums/suspensio...xperiment.html
This boot has been discussed before in several threads. It is not an exact replacement and will tear: https://ls1tech.com/forums/suspensio...-push-rod.html
So far, the only durable solutions we have found are FirstYrLS1Z making a rubber plate out of a more durable material (in link) or using an old stand-by; rubber nipples: https://ls1tech.com/forums/suspensio...xperiment.html