nomorews6

iTrader: (7)

I'm thinking about having all this: Will it get me in the 11's at sea level?

front sway bar removed, lid, borla, 4000stall/3.73 gears, skinnies, sticky tires. Will I need much more?

NXZ28

iTrader: (45)

You will need a computer tune for the stall and gears. Eliminate the torque management, raise the rev limiter, adjust for firmer shifts, and raise the shift points in the tranny. With your setup you have now, you will probably see 12.60s. That is without any weight reduction besides the sway bar. Good luck.

nomorews6

iTrader: (7)

12.60's? At sea level? That sucks. I was hoping to be closer to the 11's with that stuff. Maybe if I get headers and intake?

TA4U2NV

iTrader: (1)

well, with the mods in the sig, i'd be lucky to hit 11's with a tune, and I got a 4000 stall and 3.73's (haven't ran it at the track yet. still in the shop)

rufretic

iTrader: (37)

Add a cam and you have a chance. I ran 12.2 with with 3800 stall and f14 cam. I had 3.23s though, I just put in 3.73s and ss4000. I also changed to true duals and picked up a few ponies. I plan to be in the 11s next time at the track.

Mr_president

iTrader: (38)

good luck bro, i have all the stuff in my mods and i hit a 12.4 spinning out of the hole 1.9 60 foot and i have a vibrating drive shaft launching at 5500 rpms ! i just orderd a new drive shaft and a slp brake control kit and hopeing i will get 11 ... no one told me street and track racing are in the own differnt worlds!! track is alot differnt then street if you launch it anywhere under 4000 rpm youll bog and if you dont have a rear end the truth is good luck getting home cuz after a few runs kiss it good bye with or with out sticky tires cuz wheel hop will get you.