just got back and im pritty happy with it. what do you think?

first run was a 12.8. dead hooked with a 2.132 60 ft
second 12.7 2nd didnt want to go in... but had a 1.854 60 ft
final run was the best and i wanted to beat it but a car flipped and they closed the track.

1.819 60ft
7.898 1/8
90mph
12.22
114.98 mph


bolt ons with ms4 cam dyno tuned and 3.73 gear in the 10 bolt. bfg drs, cant wait for spring when i get a 9inch and 410s.

 

Nice run! If you can launch a little harder and get a 1.6-1.7 60ft, you will get that 11 second pass.

 

Congratulations! Good runs closing up there.

 

nice car...yea I'd think with a few more runs you should be in the 11's.

 

425whp = 115 mph? something isn't adding up, generous dyno i assume.

trap seems a bit low for the mods, but driver can play into a lot of that. nice runs.

 

Nice runs, I agree with a 9" and launching harder you'll be in the 11s for sure. Hey, did you have Speed Inc. install your cam earlier this year? I think you dropped off your car the same day I dropped mine off for a cam install.

 

yeah that was me. and i agree i think i could hit at least 12.0 and with a 9 inch with slicks i should hit at least a 11.8 or a bit lower. i was launching it at 4200 and was hooking awsome. i was gunna drop it at 4500 and i think i would have had a 1.7 60ft but couldnt run. kinda sucked.

 

and the car was dyno tuned on a dynojet at speed iinc. 425hp and 383 tq

 

great run

my best run with my Z camonly a4 stock gear 3.23
12.06 with 1.74 60'

http://www.youtube.com/watch?v=Bz1bs_glLHs

 

you should easily be in the 11's with those number and if you can get a 9" and hook up. i went to the track with my 10 bolt and ran a 12.68 with
a 2.2xx 60 foot due to the track not being preped. best run i have with my 10 bolt is a 12.58 BEFORE the cam now i've got my 9" installed and ready to run again in the cold weather.

 

MPH seems very very low for 425 rwhp......

What are you shifting at? Rev limit? Weight?

That cam, and that power should trap much higher...

I trap 6+ mph faster, with a little less power...

 

No offense but dead hook and a 2.0 - 60 ft. Spinning through 1st and some of 2nd is how you get a 2.0 - 60 ft.

Not dead hooking.

 

Dead hooking and bogging is probably what's happening.

 

yeah thats what happend. it bogged down bad... i didnt know it was gunna hook that well. the rev limiter is at 7,000 i was shifting right before that. i felt it could have been faster if i launched it at a higher rpm but couldnt get another run in...my times where getting better and better every run. im pissed i didnt get 1 more run. i bet i would have hit a lower 12 if not 11s. o well. spring time. shes getting put away sunday.