Havok2

iTrader: (118)

those of you only with 1 gauge, can you post pics?

i think im gonan go ahead and get the interceptor scangauge..and that takes the place of most gauges...

the cubby hole near the shifter is not an option...

im thinking something custom...but where?

so post your pics...

slowbrakiller

iTrader: (10)

ac vent near the driver door

slow1999blackz28

always liked that vent by the driver door, or maybe a single gauge pillar pod.

Havok2

iTrader: (118)

yeah, ac vent might be an option
not the pillar, i think the pillar needs 2 or 3 gauges to look complete..

slow1999blackz28

well what about down at the bottom of the center console?

slow

iTrader: (7)

I like that location, I used to have a gauge there on my car, worked great.

Ryan

benoh

iTrader: (13)

Have you looked into the 6LE design? You can replace any AC vent or cubby hole to fit a gauge.

Here's the link.
http://6litereaterdesigns.com/produc...onsole-plates/

Havok2

iTrader: (118)

no, thats not an option, i already have a bezel there with buttons and other accessories...

the ac vent? ill see whats up with that...

Chrome355z

iTrader: (1)

Question where can the panel that fits in the cubby hole in the picture above be found at? I love the look of the install and want to install an interceptor in that location.

Is that out of a Trans Am, Camaro, Aftermarket???

It looks factory. Thanks!


And if anybody knows what was the up/down switch originally for? I'm sure I can wire it to something, maybe a cut-out open/close down the road!