New Trans Am Bumper!
Yeah I think it's safe to say it's not very possible to do this.
1. There's no plate
2. The exhaust work would be a pain in the ***.
3. I can't photoshop a real car
I'm really just bored.
1. There's no plate
2. The exhaust work would be a pain in the ***.
3. I can't photoshop a real car
I'm really just bored.
Probably would be better to keep the exhaust tips in their factory locations and fabricate the diffusers in between them.
I've been contemplating this rear diffuser idea since I first saw them on the Ferrari F1 cars. It would be easier and more cost effective to relocate the licence plate rather than the entire exhaust.
I've been contemplating this rear diffuser idea since I first saw them on the Ferrari F1 cars. It would be easier and more cost effective to relocate the licence plate rather than the entire exhaust.
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo
Awesome K5 Blazer Restomod Comes With C7 Corvette Power
Verdad Gallardo
10 Camaros You Should Never Buy
10 LS Engine Myths That Refuse to Die
Verdad Gallardo
Five Reasons the Camaro Was the Most Pivotal Player in the Pony Car Wars 2.0
Brett Foote
10 Reasons the LS7 Is GM's Most Extreme Naturally Aspirated V8 Engine Ever
Verdad Gallardo
I say throw out the center mount idea becuase it makes our cars look like they are tippy toing or something. Just do that diffusor with stock located or similar tips, and a license plate in place.
x2 on the link for that corvette.
x2 on the link for that corvette.
Putting the exhaust tips in the original spot would make it look exactly like a regular trans am. So.. lol. I cut a lot of the previous bumper off cause it wouldn't fit right
edit: and I just realized that there are diffusers there. Wow, lol. I'll give it another go later
edit: and I just realized that there are diffusers there. Wow, lol. I'll give it another go later
TECH Fanatic
Joined: Dec 2001
Posts: 1,114
Likes: 0
From: Way the hell in front of you
Maybe put the plate where the pipes are and one 3.5" pipe on each side of the plate?
And possibly instead of it being smooth, put the "ridges"? on it like on the 2010 camaro to bring the bumper down a little - sits too high.
And possibly instead of it being smooth, put the "ridges"? on it like on the 2010 camaro to bring the bumper down a little - sits too high.
id say put the license plate in the ta filler panel. You would have to get rid of your key hole or make it so you license plate flipped up.
Last edited by firehawk#682; Apr 9, 2009 at 01:13 PM.
