homemade ebrake boot
homemade ebrake boot i made this out of some vinyl. it turned out all right. sorry about the bad pics, camera phone. it was my first time sewing vinyl. it is a bit bigger on the front/bottom part than i meant it to be. i might make another one later that is better and tighter.
any tips from you guys who do interior work?
any tips from you guys who do interior work?
it attaches to these little plastic hooks on the underside of the panel. same part the factory rubber piece connects to. i cut some holes to put them through then hot glued it on.
Trending Topics
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo
Awesome K5 Blazer Restomod Comes With C7 Corvette Power
Verdad Gallardo
10 Camaros You Should Never Buy
10 LS Engine Myths That Refuse to Die
Verdad Gallardo
i dont like how it covers part of the actual handle. maybe if you made it end right at the handle, making it tight around the shaft, it will look better. now it just looks like you slipped something over the assembly.
Awesome, I have alot of pleather left over from redoing my dash. So I was thinking about using some of that. But I can't sew for squat. I'd probably have to ask my aunt or something. Can't wait to see the Auto shift boot!
i gave it a try on the shifter. was harder than i thought it would be, the sewing is getting easier though. the fitment isnt perfect because my stock retainer ring is broken.
