Trans Am Diffuser, CETA area, installed...
non CF one for sale I have decided to possibly sell the car, so I am not going to put it on. I got it a couple weeks ago and it has only been out of the box to inspect/ test fit. Nothing wrong with it.
Looking to recoup most of what I paid for it, $325 + shipping
Email me at blownbird97@yahoo.com
Thx
Looking to recoup most of what I paid for it, $325 + shipping
Email me at blownbird97@yahoo.com
Thx
Is the exhaust opening the same size as stock or does it give up some room? I guess what I am trying to ask is how big of a tip can you fit back there. I wanting to run some 7.5" Mecham power ovals.
I'm pretty sure your going to give up some space, depending on the width of the diffuser that is right around the exhaust openings.
Not sure size wise how comparable those Mechams would be to mine. I have b+b quad tips and they are definitely touching. If not pretty much pressed against them a bit towards the narrow part of the opening. I just have to adjust them forward a bit.
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
Gas Monkey Built a 6-Wheel Ferrari Testarossa With a Corvette LT4 Engine
Verdad Gallardo
7 Most Reliable High-Performance Engines GM Has Ever Built
Verdad Gallardo
Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin
Verdad Gallardo
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo Please post some photos of both of these mods when finished.
I like the idea a lot, but think it would look a lot better if the diffuser fins had a slight curve under the car and not just straight down. I think it makes it look like an add-on and not like it was meant to be there. If they had a slight curve i would have gotten it 
I like the idea a lot, but think it would look a lot better if the diffuser fins had a slight curve under the car and not just straight down. I think it makes it look like an add-on and not like it was meant to be there. If they had a slight curve i would have gotten it
I'm kinda suprised too. I would email them but I hate to bug them especially when I'm not ready to spend the money just yet. I hate for them to waste their time. I know they always have a lot going on.
I don't have an unaltered one here to measure so I can't give you an exact number but I can tell you that it completely follows the lines of the bumper underneath so the exhaust opening is only the thickness of the fiberglass (about 1/8") smaller than a stock TA opening. You still should get the exact measurement since you know what you want to do in your head but I hope this helps.
Any chance you can start making one with these contoured fins? What would it take to make this justifiable for you?