How hard would it be to make THIS front splitter?
06-22-2017, 01:37 PM
#21
The center portion for ducting and the bent braces are all 1/16" Aluminum. The compressed section that matches the body shape is PVC plate.
I designed the shapes, and had it CNC cut. the part where it meets the lower portion if the bumper was carved by hand with a grinder. A dirty job.
I designed the shapes, and had it CNC cut. the part where it meets the lower portion if the bumper was carved by hand with a grinder. A dirty job.
06-27-2017, 10:33 AM
#22
Mine is close to that and is truly functional as it is 6mm composite mounted up to the frame. The IROC TA was the inspiration for my design.
You can see some of the air box and mounts in this shot.
With and without.
Tested to 170mph on track.
Lots more going on than is visible.
You can see some of the air box and mounts in this shot.
With and without.
Tested to 170mph on track.
Lots more going on than is visible.
