GHall8788

Hey guys, i installed a B&M ratchet shifter in my 2002 Z28 a few weeks ago, i want a manual looking console in it now. I can tell the M6 console will sit to far forward for my set up (i have attached a picture). Does anybody know of a M6 looking console for an A4? or how to convert your A4 to look like the M6. I want the full M6 look because i want the park, reverse, etc part gone. Any help appreciated, thanks.

GHall8788

also do you think i could cut my a4 and fit a shift boot on it?

HioSSilver

iTrader: (8)

I have a friend that has a m6 console from parting out his car. Pm me if interested.

GHall8788

i would, but it wouldnt fit right.

PontiacFan

iTrader: (104)

It's been done, ..., Search for shifter threads, or aftermarket shifters threads or something like that in the A4 forum & this appearance forum.
I don't remember for sure which forum they are in.

High School Goat

iTrader: (1)

I doubt it would be hard to make one fit properly.

Jadedbird

iTrader: (27)

You could buy an m6 :B

BIG_MIKE2005

iTrader: (116)

I believe all that it required is to trim either the rear or front of the boot area for the auto shifter. I looked into this quite a bit when I was on the fence about going to an auto set-up.

whiteheartbeat

iTrader: (4)

You pretty much have to eliminate the ashtray on the m6 console if you want to be able to shift into first. The m6 console will work fine if you keep it in drive, just won't be able to shift down. I have an m6 console that I just tried last week!

Empatho

iTrader: (16)

+1
I was driving with an m6 console on my auto for a couple months until I swapped the a4 to m6.