AN fittings and braided lines question
AN fittings and braided lines question Im getting rid of my old catch can and switching to a Morose setup, but this time I dont want to just use rubber hose, i want to use AN fittings and braided lines to dress it up a bit. I want to find a fitting that will fit over the stock valve cover nipple and then go to an AN male end, where i can then add the female and braided lines.
I tried searching, but i can figure out what to call it, or if it even exists.
Thanks
I tried searching, but i can figure out what to call it, or if it even exists.
Thanks
Im getting rid of my old catch can and switching to a Morose setup, but this time I dont want to just use rubber hose, i want to use AN fittings and braided lines to dress it up a bit. I want to find a fitting that will fit over the stock valve cover nipple and then go to an AN male end, where i can then add the female and braided lines.
I tried searching, but i can figure out what to call it, or if it even exists.
Thanks
I tried searching, but i can figure out what to call it, or if it even exists.
Thanks
Well theres a fitting that attaches to my stock fuel line and has an AN fitting on the other side. So i was just assuming i could find that for the valve cover and valley cover.
Do the ones on the valve covers have a barb or a lip on them? I have fabbed ones so I don't remember. If they do you could probably get away with using a quick connect fitting. However they are around $35 each.
Staging Lane
Joined: Sep 2013
Posts: 50
Likes: 0
From: Palm Beach FL
I use quick connect fitting with plastic locking insert to -6AN line into catch can. I use same fittings on my fuel pressure regulator as well
Look up:
15117 - 5/16'' FEMALE QUICK CONNECT TO ORB-06 PORT
Look up:
15117 - 5/16'' FEMALE QUICK CONNECT TO ORB-06 PORT
