Front lip..
Looks like ebay foam "Splitter" or a custom job. Looks more custom because of the tapering of the thickness closer to the wheels but its hard to tell anything from this pic unless your familiar with the car.
someone posted a pic of the same car asking the same question like a couple weeks ago. go back a few pages and see if you can find it, not sure if anyone had a solid answer, but I believe cancam99ss's answer is what came up in the other thread.
Trending Topics
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
Gas Monkey Built a 6-Wheel Ferrari Testarossa With a Corvette LT4 Engine
Verdad Gallardo
7 Most Reliable High-Performance Engines GM Has Ever Built
Verdad Gallardo
Amazing '71 Camaro Restomod Is Modern Muscle Car Under the Skin
Verdad Gallardo
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo
^^^ I was looking at wrench36 instagram like someone up above said and it looks great from the side but from the front angle and the fact that there are no clear HD pics of the chin, it looks a bit awkward. Since the curve of the chin is so sharp it doesnt really flow too well with the bumper and the corners look to be attached to the bumper in a way that makes the corners mount higher than the middle of it. I think if there was some decent support on it to make it look parallel to the ground in the front then I think it would look pretty sweet.
