Bright Ideas
mirror itself, ive seen it done a few times but never offered up, considered doing it on mine by just backlight the inside of the housing with a red led if it was bright enough that would light up the gap. of course if there was a kit i would be more than onboard
Thread Starter
Launching!
Joined: Feb 2014
Posts: 281
Likes: 0
From: Cape Coral Florida
I thought about backlighting mine, but figured I'd just end up breaking it. The mirror itself is kinda small for an arrow or design, maybe just a strip down the outter edge?
id have to see it done.
funny i did a search and found a thread i started asking about this from 06, couple of people did it and made a write up for it, but i never did it obviously.
funny i did a search and found a thread i started asking about this from 06, couple of people did it and made a write up for it, but i never did it obviously.
Trending Topics
LS1 Tech Stories
The Best V8 Stories One Small Block at Time
6 Common C5 Corvette Failures and What's Involved In Repairing Them
Pouria Savadkouei
Retro Modern Bandit Pontiac Trans AM Comes With Burt Reynolds' Autograph
Verdad Gallardo
Top 10 Greatest Cadillac V Series Performance Models Ever, Ranked
Pouria Savadkouei
Top 10 Most Powerful Chevy Trucks Ever Made!
Hennessey's New Supercharged Silverado ZR2 Has 700 HP
Verdad Gallardo
Coachbuilt N2A Anteros Is an LS2-Powered C6 Corvette In Italian Clothes
Verdad Gallardo
Awesome K5 Blazer Restomod Comes With C7 Corvette Power
Verdad Gallardo
10 Camaros You Should Never Buy
10 LS Engine Myths That Refuse to Die
Verdad Gallardo well all the pics are gone and the writeup no longer works, but from what i remember yeah it looked pretty good
pics still work in this thread and it was about the same other than red instead of orange
https://ls1tech.com/forums/appearanc...g-signals.html
pics still work in this thread and it was about the same other than red instead of orange
https://ls1tech.com/forums/appearanc...g-signals.html
well i think there was some cutting involved, in the thread i started there was a response about taking a carbide bit to the mirror surface in the desired pattern to allow the light to shine through
12 Second Club
Joined: Jun 2012
Posts: 1,548
Likes: 1
Thread Starter
Launching!
Joined: Feb 2014
Posts: 281
Likes: 0
From: Cape Coral Florida
TECH Junkie
Joined: Nov 2013
Posts: 3,913
Likes: 366
From: White Bear, Mn
very true
Thread Starter
Launching!
Joined: Feb 2014
Posts: 281
Likes: 0
From: Cape Coral Florida
On the outside like that is a little too rice a roni for me, I don't think I could make that look right. I'm liking the screamin chicken in the mirror glass. I think I could pull that off.