f-bodman

Looks good, Bryan did mine also. I went to my first car show last night and had quite a few people asking about them. You know when people ask if it came like that stock he did a hell of a job.

1SS2LUV

very nice work

y2k_ta

iTrader: (80)

Nice idea. Now how do you install them without destroying all your hard work? I left mine the black factory plastic (still says "Corvette") mainly because they were such a bear to install (even after they were trimmed to fit).

BTA 123

Bad ***

parbreak

iTrader: (17)

I send complete install instructions with the covers. They are not THAT hard to install but I do recommend taping certain sections with blue painter's tape to avoid scratching the finish. The cut on the passenger side eliminates any
scratches on that side, it's pretty easy to install. This particular set does not have the cuts for the AIR system since it was removed on the car. If the car has the AIR intact, then a cut is made in the rear to accomodate that.

Bryan
parbreak

SCamaroS

Wow with a little time and creativity FRCs can make a big diference under the hood. I wish i was artistic though...

slik98z

Damn those look pretty freaking sweet! awesome job.

while we are on the discussion of fuel rail covers...does anyone wanna tell me how i can get my driver side FRC to clip on with a fuel pressure safety switch for a nitrous kit? it seems like i have to cut down part of it...the front half of the fuel rail cover wont clip in cause the FPSS is inthe way...any suggestions?

awesome job again!
Travis

Dawg One

Dawg One

No Juice

iTrader: (11)

They just make things look so much better

F-bodman --- Is that your lid on Byan's web page with the silver stripes? it looks like it matches your FRC's.

Here is a question for everyone, What STB do you recomend with the FRC's so they are not obstructed as much as possible? I was set on the Hotchkis one but now after seeing Dawg's, I don't know?

Parbreak (Bryan) Have you done any SOM FRC's yet, any pics? Just curious how it looks with the orange of the engine bay.

parbreak

iTrader: (17)

I've done quite a few SOM FRC's and they look great with the SOM in the engine bay. I am very partial to color matching with the car's paint code because it makes the FRCs look stock and like they were meant to be there.

As far as STBs go, pretty much any one will work EXCEPT SLPs. BMR , Hotchkiss work just fine.

And not to answer for FBodman, but yes that is his lid on my page. Carl came up with the design and we did it.

thanks
Bryan
parbreak

f-bodman

Yup, as Bryan said that's my lid and yes it does match the frc's



Which match the stripes on the car

blkformula95

those are sweet man. ill look for my set in the mail...